Component Specific Heat Shield and Insulating Products
*Versa-Shield
Originally designed to protect starters from heat, Versa-Shield can also be used to protect cool cans, carburetors, fuel pumps and many more areas of a car, boat, RV or heavy-duty truck. It has also been found helpful for shielding electrical boxes and instruments from intense heat. Versa-Shield can easily be cut to shape, and attaches to itself with hook and loop material. Versa-Shield will fit most starter assemblies. Simply cut off excess material with scissors or a sharp knife.
*Turbo Insulation Kit
This turbo kit is designed to fit all turbos from the sport compact turbos to the large over the road trucks. Designed to reduce turbo lag and reduce under hood temperatures, the Turbo Insulation Kit adds additional horsepower while protecting costly components from unwanted heat. The kit comes complete with all the materials necessary for a clean, professional looking installation.
*Air Intake Tube Cover Kit – Cool Cover
The Air Tube Cover Kit is designed to prevent air tubes from becoming heat sinks. Made of heat treated fiberglass with a reflective coating, the Air Tube Cover will reflect heat away from the air tube and allow cooler air to be introduced into the intake for a denser air/fuel charge. The Air Tube Cover can be installed/removed in seconds without the use of tools by a full-length hook & loop closure system. Easy ON for GO, Easy OFF for SHOW ! The air tube cover is available in a 36” long by 14” wide that can easily be cut to size for smaller applications.
*Cell Saver – Battery Insulation Kit
DEI’s NEW Cell Saver is the Ideal protection for any automotive battery. Batteries are very susceptible to heat and vibration that could cause premature failure and hazardous leaks. Cell Saver is very capable and will absorb and neutralize any damaging leaky battery acids. DEI’s Cell Saver’s material is capable of withstanding radiant temperatures up to 2000° F.
*Hub & Rotor Cover
Design Engineering, Inc. (DEI) has introduced their Hub and Rotor Cover to protect professional mechanics and backyard do-it-yourselfers alike from the potential of serious burns. Working in and around hot brake drums and rotors such as changing shocks, springs or suspensions can be a painful experience without some type of protection. It’s not just for shielding against harmful hot spots but can also act as a guard against any sharp edges and protect against dirt, dust and airborne particles around the track, shop or backyard garage.
*Aluminized Plug Wire Sheaths
Manufactured of the same material as Heat Sheath. The Plug Wire Sheath was designed as an inexpensive protection for plug wire boots or any spot on a plug wire that is close to heat and requires additional protection. The Aluminized Plug Wire Sheaths can also be used on lines, wires and hoses that need protection in a specific area. The Aluminized Plug Wire Sheaths are 6 inches long and 3/4 inches in diameter.
*Dyno Strap Heat Guard
Design Engineering, Inc (DEI) has developed a product that offers burn-through protection for dyno tie-down straps. Made of a high-temperature resistant aluminized mylar material, DEI’s Dyno Strap Heat Guard will withstand 500°F direct heat and 2000° F of radiant heat. It measures 5” wide by 3 feet and easily slips over dyno tie-down ends and slides over strap to be positioned near the area where exhaust heat exits.